JurassicJeep.com
About  |  Jeep #12  |  Jeep #18  |  Jeep #29  |  Reference  |  Shop  |  Forums

Jeep #12: Fuel Tank and License Plates

Since it was in the 70’s today I decided it would be a good time to get some much needed work on the Jeep. I was ambitious to think that I would be able to get all of the work done today, but the rust monster has struck again. I intended to repair the rear frame area rust, which unfortunately requires removing the gas tank. It took a lot of cutting, cursing, and cramping but I managed to get the gas tank out after a few hours. Most of the rubber hoses will need to be replaced however, because when the tank was last installed (either by someone, or at the factory) all the clamps were installed upside down and inaccessible.

I will have to resume the welding sometime later this week.

In the meantime I had some stickers made and I decided to see how they would look like on a license plate blank. They need some tweaking and overall are too big, but a set in the right direction for an accurate license plate. (BTW…. would anyone like to buy one?) I also took a quick shot of my work area’s Jurassicness.

  • No comments yet

Leave a Comment

* are Required fields



© 2010 - 2024 Jurassic Jeep - Created by AJ Quick - Jurassic Park is a Registered Trademark of Universal Studios & Amblin Entertainment, Inc